Related Articles
Auto Calibration Happens, but stylus not Responding or It is behaving in haphazard manner
Open EyeRIS UI from the taskbar, click on setting icon and select Debug View, a window will open and it should look something like below image. If the debug view is (as shown below), then make sure your EyeRIS is installed in the center of the ...
Stylus not getting detected after Auto-Calibration.
Check for Stylus charging, try charging stylus with provided USB cable for 3 min and try again. Check for “Pen and Touch Support” in System Properties. It should show “Pen and Touch support available with 255 touch points”. If it’s showing “No pen ...
Stylus and touch are not in Sync after Auto Calibration i.e. the touch pointer is running away from stylus on left and right side of the active area.
This issue comes due to graphic driver settings in windows 8/8.1, If EyeRIS is being used on a laptop connected to a projector and there are two displays i.e. One of laptop and one of a projector, in this case, it is required to scale the display ...
How does Automatic Calibration works?
EyeRIS 8-Series and IX-Series uses an automatic filter switcher, that is able to switch between visible band pass filter and IR band pass filter. In visible band pass filter, EyeRIS is able to track pattern from projected image enabling the system to ...
Scenarios when Automatic Calibration may not succeed.
When there is an obstruction between the projection and the projected surface i.e. a whiteboard, wall or screen. When the EyeRIS unit is installed incorrectly. When there is some external light reflection from window/door falling on the board ...